![]() ![]() When enabled, the module where a value was changed will send an UDP broadcast to a port (default 21324). Note: this info is partly out of date, see updated functionality in the code ( udp.cpp) Sync packets received from pre-0.13.0 instances are treated as if sent in sync group 1 only. Make sure the sender and receiver you want to sync both have the same sync group ticked (a sender can send to multiple groups and a receiver can listen to multiple groups). This allows syncing select instances only without changing the UDP port.įor example, you might use one sync group per room you use WLED devices in. Sync groupsįrom v0.13.0, 8 Sync groups are available. You can easily group WLED devices (for example all in one room) by changing the UDP port of all devices you want in that group. The quick toggle in the main UI will only apply to direct changes (UI + API), all other sync type sending behavior remains unaffected. Sends notifications twice (if you have issues with UDP packet loss) Whether to send sync after a macro was triggered Whether to send sync after a connected Philips light changed Whether to send sync after changed by Alexa (you may use Alexa groups instead) Whether to send sync when toggled by the physical hardware button Whether to send a sync notification when state changed via the web UI or API If the sync is toggled on in the main UI and the corresponding checkbox in UI settings is checked, everything is received.Ī sync receiver will not assume the state of the last sender directly after booting, a new packet must be send for it to react. If all checkboxes are disabled, nothing is received by default after each boot. Whether the effect settings should be applied Whether the color of the synced device should be applied If there is a sync notification, whether its brightness should be applied If your sync settings are not the way you like on boot, check the WLED Broadcast section in Sync settings, where you can specify what is sent and received by default: Receiving settings Setting In UI settings, you can set whether this button only turns on/off sending (default) or also receiving, with the option Sync button toggles both send and receive. You can set the specific behavior of it in Sync settings, also you can choose if all aspects or only brightness/color/effects are applied.Īdditionally, there is a "Sync" quick toggle for it in the main control UI! The UDP notifier function of WLED makes it easy to sync multiple lights to the same color/effect, enabled by default. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |